1 Remove all of the cover
2 Remove the control panel
3 Remove the formatter
4 Remove the right side handle
5 Disconnect the fuser cable
6 Squeeze the air duct to release two tabs (callout 1), and then lift the air duct out of the printer
7 Disconnect nine cables (callout 2 ) six cable at the top and three cables at the front of the ECU.
8 Lift the cartridge door switch (callout 3) from it mounting.
9 Disconnect the laser/ scanner cable (callout 4)
10 Remove four screws (callout 5) two screws on the top and two screw on the side, at the bottom, of the ECU pan.
11 Remove three screws ( callout 6) from the back of the ECU pan.
12 Rotate the top of the ECU pan away from the printer, and then disconnect one flat flexible cable ( callout 7 ).
13 Lay the ECU pan down on the work surface , and then disconnset three cables( callout 8 ).
For parts pricing and availability contact:
Sales@metrofuser.com or
http://www.metrofuser.com/