Browse
 
Tools Add
Rss Categories

HP color laserJet CP3525dn error

Author: Metrofuser Tech Support Reference Number: AA-05240 Views: 9763 Created: 2012-04-12 03:29 pm Last Updated: 2012-04-12 03:29 pm 0 Rating/ Voters

HP CP3525   fuser error

50.8 Fuser error.  The fuser has experienced a low temperature error.  Recommended action, remove any paper jams from the fuser area.

Reinstall the fuser. check the connector (J50) between the fuser and the product. Replaced the cable or fuser if the connector is damaged.

If the problem persists, replace the fuser.

50.9    Fuser error.  The fuser has experienced a high temperature error.  Recommended action,  reinstall the fuser, check the connector ( J150)

between the fuser and product.  Replaced the cable or fuser if the connector is damaged, if the problem persists replaced the fuser.

50.     Fuser error.     A fuser error has occurred.  Make sure you have the correct fuser, reseat the fuser. Turn the unit off and back on.

51.20  error       The black laser(51.20) or cyan laser(51.21) has experienced an error. Reconnect the connectors of the laser driver PCA

(J503) and the DC controller PCA (J111).  If the problem presists, replaced the fuser.

51.22  Error       The  magenta laser (51.22) or yellow laser (51.23) has experienced an error.  Reconnect  the connectors of the laser driver PCA

(J501) and the DC controller PCA (J110). if the problem presists, replaced the yellow and magenta laser scanner.

50.4   Fuser  error.  The fuser driver circuit has experienced an error. Recommended action, Check the power source , reconnect connector (J101)

on the DC controller PCA. If the problem persists, replaced the low voltage power supply.

50.5   Fuser error.  The fuser has experienced a type mismatch error.  Recommended action, reinstall the fuser. Check the connector (J50) between the fuser and

the product. replaced the cable or fuser if the connector is damaged.  Reconnect the connector (J139) on the dc controllerPCA, if the problem presists, replaced the fuser.

50.7   Fuser error. The fuser has experienced a pressure release mechanism error. Recommended action, reconnectors(J117, J123) on the DC controller PCA.

Run the sensor test to test the fuser pressure release sensor, if the sensor is defective, replace the fuser.

55.00.00  DC  controller error.   The DC controller has experienced  a  communication error.  Recommended action, turn the printer off and then back on .

IF the message persists, replace the DC controller PCA.

55.01. DC controller error.  The DC controller has experienced a memory error.  Turn the unit off and then turn the unit on, fi the message persists, replaced the dc controller

PCA.


Rss Comments
  • There are no comments for this article.
Info Add Comment
Nickname: Your Email: Subject: Comment:
Enter the code below: