HP 4700 color laser jet printer, 55. error,
A printer command error has occurred.
O1. DC controller memory error, 02. dc controller memory 03. no engine response
04. communication error. 05
RFU error. Codes 01-02 replaced the dc controller, code 03-04 1. reseat
Formatter 2 Check all connection on the dc controller 3 upgrade formatter and dc controller
firmware, which can be found in a single rfu file.
HP 4700 color laser jet printer, 40 error
embedded I/O bad. A connection
with the
Embedded jetdirect print server has been broken. 1. press green check button to continue
Printing 2. Power
cycle the printer 3. resent the print
job 4. If the error still occur,
replaced the EIO card in slot X or the formatter.
HP 4700 color laser jet printer, 41.3
unexpected paper size in tray.
This mean that
Media that is load is
longer or short than the feed direction then the size configured for
The tray. 1. make
sure the correct setting are set for the trays.
Run a paper path diagnostic test to determine if all sensor are working
correctly. If the problem persist
Replaced the paper feed assembly.
HP4700 color laser jet printer, 11.x
clock error. This message is
display when there
Is a problem with the real-time clock on the formatter
board. Recommended action is
To replaced the formatter assembly.
HP 4700 color laser jet printer, 13. xx.yy. This is a jam in the duplex path . 1
Remove the paper, Run the paper path test to determine if one are more of the
sensor are not working correctly. 2 Check
the oblique roller on the back side of the ETB to ensure they are not worn or
dirity. IF need upgrade the formatter
and DC controller firmware
3 replaced ETB and check all cable connection to and from DC
controller
HP 4700 colcr laser
jet printer 60 .x error, Printer
error. A tray lifting error has
occurred, turn the printer off then on.
Install the tray and listen carefully, you should be
Able to hear the paper stack being lifted. You can also
watch the paper level indicator on the front of the tray moves. Check the
following connectors, tray 2 J4618
on the lift motor and J1015 on the DC controller. Check tray 3 J8120 on
the lift motor and J8102 on
The paper feed PCB,
if needed replaced lift motor assembly.
HP 4700 color laser
jet printer, 62 error, No system was found. Turn the printer off then back on , reseat
the firmware compact flash, making sure that it is in the first slot.
If needed replaced the firmware compact flash and the
formatter.
HP 4700 color laser
printer, 10. error Cartridges
not engaged. The printer
cartridge is not seated properly. A
10.92 black cartridge 10.92 01 cyan
cartridge 10.92 02 magenta
10.92.03 yellow cartridge. Make sure that the ETB is closed, 2 Remove and reinstall the affected
cartridge. 3 Make sure the cartridge guide for the affected cartridge is
installed correctly.
HP 4700 color laser printer, 10.90
error A color cartridge is out
of toner and need to be replaced.